TheSwamp

CAD Forums => CAD General => Dynamic Blocks => Topic started by: Kate M on September 04, 2008, 04:11:33 PM

Title: XY Parameters
Post by: Kate M on September 04, 2008, 04:11:33 PM

Anybody ever use one? Every time I've tried, it hasn't done anything that two stretch actions wouldn't do better. I'm just curious to see one actually working.

(And this is just me, just my curiosity -- nothing 'desk-y about it.)

Title: Re: XY Parameters
Post by: jnieman on September 04, 2008, 04:15:12 PM

I haven't delved into dynamic blocks much in a while... development of our library got put on hold due to being balls to the wall, pretty much... but I have to admit, the only times I had used it... I am betting that the stretch would have been better... it seems like I used XY just because I hadn't used it at that point, and wanted to use it for the sake of using it.

Title: Re: XY Parameters
Post by: Dave R on September 05, 2008, 08:23:33 AM

I've used it for arrays within a dynamic block.