http://www.theswamp.org/index.php?topic=54165.new#new
It is actually my save code. when i save the dwg with my customer save and i reopen the dwg, I get the recovery prompt.
I never had an issue with this code till now.
any suggestions?
Does it occur when you start a new 2019 template, save, and reopen?
both it appears any dwg saved with my custom save is causing this
Does the error occur with a previously saved drawing
or with a newly named drawing
or both ?
http://www.theswamp.org/index.php?topic=54165.new#new
It is actually my save code. when i save the dwg with my customer save and i reopen the dwg, I get the recovery prompt.
I never had an issue with this code till now.
any suggestions?
Update your code, or don't use it...does the Recovery Prompt go away IF you don't use the code you mention in the post I quoted?
Post the code, let's all have a look at it.
i do not get a recovery prompt if i dont use my custom code.Andrew...
I have used this custom command for a few years. never been an issue till the new version
i do not get a recovery prompt if i dont use my custom code.Andrew...
I have used this custom command for a few years. never been an issue till the new version
Why do you need the ver.20 check in the code?
What dwg-version are you saving your files to in R2019?
It's appears either no one here has R2019 or no one wants to try your code on their PC: are you simply trying to save your file in two locations at the same time?
dont know. I havent thought about it.Post the code, let's all have a look at it.
The code is here : http://www.theswamp.org/index.php?topic=54165.msg587819#msg587819
andrew: I meant to ask ;
What happens if you add Audit the drawing after you save it with your routine?
and, are you still using the same routine?
check for versions because there are a few in the office who refuse to leave R2014i do not get a recovery prompt if i dont use my custom code.Andrew...
I have used this custom command for a few years. never been an issue till the new version
Why do you need the ver.20 check in the code?
What dwg-version are you saving your files to in R2019?
It's appears either no one here has R2019 or no one wants to try your code on their PC: are you simply trying to save your file in two locations at the same time?
Lisp works fine here in R2019 as well: wonder what other settings Andrew.. has that we do not.