TheSwamp
CAD Forums => CAD General => Topic started by: DanB on June 04, 2012, 09:00:50 AM
-
See attached.
Polyline shown with a width (3.0) and a non-tangent line creates an obnoxious "pointy" segment. Anyway around this? It is a closed polyline and would prefer to keep it that way.
-
I recreated it, and found one way is to cheat and add a few tiny segments to it.
(http://i539.photobucket.com/albums/ff357/deegeecees01/PLineTang001.jpg)
(http://i539.photobucket.com/albums/ff357/deegeecees01/PLineTang002.jpg)