TheSwamp
CAD Forums => CAD General => Dynamic Blocks => Topic started by: Shinyhead on March 24, 2008, 10:30:35 AM
-
Here you go. Just a pan head screw with or without a nut.
stretchable and the threads behave for the most part.
-
I havn't had the opportunity to look at it yet, but it sounds way cool .. is it only stretchable as in length or can you also modify the thickness.
I can see this solving most of my issues where bolts are concerned. I'll use this as a base to configure adjusting thread pitch and count, as well as bolt type, and head type ... one stop shopping ...
Dang .. see how excited I can get over a simple bolt!!
-
dude, simple as in SIMPLE.
its for millwork so its just a representation. Don't get too excited. :-P
-
dangit .. bubble burst ... :(
-
Pretty nice looking.