TheSwamp

CAD Forums => CAD General => The Third Dimension => Topic started by: sea-dawg on August 27, 2008, 05:29:39 PM

Title: sweeping solids
Post by: sea-dawg on August 27, 2008, 05:29:39 PM

iIs there a way to sweep a solid? If I draw two circles, extrude them, then subtract them from one another, is there a way to sweep that solid? If so could some one please explain on how to do that? I was looking at a website that had different tutorials and it showed them sweeping a piece of square tubing (I dont know if it was a solid or not) but they showed it sweeping around a spline, and they didnt go in to any detail on how do it. Any help would be great!

Thanks!

Title: Re: sweeping solids
Post by: sea-dawg on August 27, 2008, 05:31:58 PM

never mind, i figured it out... i think!!

Title: Re: sweeping solids
Post by: mjfarrell on August 27, 2008, 05:49:58 PM

Quote from: sea-dawg on August 27, 2008, 05:31:58 PM

never mind, i figured it out... i think!!

That's exactly how you do it!  :wink:

Title: Re: sweeping solids
Post by: jnieman on August 27, 2008, 05:50:59 PM

Glad I could help!

Title: Re: sweeping solids
Post by: sea-dawg on August 28, 2008, 07:50:45 AM

Quote from: mjfarrell on August 27, 2008, 05:49:58 PM

Quote from: sea-dawg on August 27, 2008, 05:31:58 PM

never mind, i figured it out... i think!!

That's exactly how you do it!  :wink:

Thanks ole buddie!