Hi
I have quite some trouble working with DWG coming from Revit. Especially how families are being translated into blocks.
Many probably probably would say: don't use DWG output in the first place, ..ok.. I know.. but sometimes it is necessary anyway
Revit make unique blocknames for every instance but at the otherhand... and insertion points is the same!!
That is quite the world upside down for a AutoCAD block user.
So I have a little challenge to modify these definitions.
On this that helps is the recent 'ssb' select similar blocks routine from Lee MAC.
BUT.. I you would use that on Revit output all the blocks will be layed upon each other.
I was thinking maybe the CBIR change block insertion routine could be rewritten to parse multiple blocks
whereas for the insertion point the center of the geometry will be used.
Anyone you understands this story and have any idea (for other workarounds), I would appriate it.
Thanks
Hans
**
ATTACHED: THE VARIANT OF LEE MAC ROUTINE THAT CAN BE FOUND AT
http://lee-mac.com/changeblockinsertion.htmlPLEASE READ THE COMMENTS TO GET THIS ANY FURTHER. THANKS
**