Author Topic: Offsetting Plines (Read 4253 times)

Jürg Menzi · « **Reply #30 on:** August 09, 2005, 09:17:17 AM »

Can reproduce the problem in 2005 but with another effect (only a part of the pline is offset).
Try to offset the obect with different distances and then back to the required distance... that's all I can say for the moment.

Keith™ · « **Reply #31 on:** August 09, 2005, 09:52:45 AM »

For one thing, the elements in the drawing are at different z elevations

jonesy · « **Reply #32 on:** August 09, 2005, 09:55:12 AM »

Quote from: Keith

For one thing, the elements in the drawing are at different z elevations

Forgive my ignorance Keith, but would that make any difference between not working on his and working on my machine?

Keith™ · « **Reply #33 on:** August 09, 2005, 10:09:23 AM »

I dunno, it works fine on my computer, except I couldn't match the offset distance because of the differing z elevations and my lack of desire to do so....

I presume you both are running the same version of AutoCAD ... I would do a comparison of sysvars between your setup and the errant system.

jonesy · « **Reply #34 on:** August 09, 2005, 10:19:31 AM »

Couple of other things I have tried

1. Offseting small distances at a time until the required distance is achieved

2. Resetting the profile to the original one that was created when Autocad was installed.

I am really confused about this one

News:

Author Topic: Offsetting Plines (Read 4253 times)