TheSwamp
CAD Forums => CAD General => Topic started by: Mark on September 09, 2005, 07:04:35 AM
-
What command would you use to apply the properties of a table cell to other table cells?
-
hmmmm...
cut & paste ?
:-o
Have to look...I don't use table in AutoCAD..
does any one do ?
-
Apparently not. w00t! I stumped the CAD Geeks.
-
Well, since I don't use tables and cells (in fact you CAN'T use them in 2000/4) ... I am at a disadvantage ... but as soon as I migrate to 06, you can bet you ass I'll know the answer then ...
-
_.MatchCell