TheSwamp
CAD Forums => CAD General => Dynamic Blocks => Topic started by: T-Square on September 05, 2014, 01:59:36 PM
-
Hello,
I know I know...someone can do it better. :-) So be it....
See attached. Problem I am having is the "Custom" string I had a while back in the "Block Properties Table"... I can't seem to find a way of removing it.
Does anyone know how to remove the "Custom" string so that it's not there and does not show up in the Properties manager?
Thanks in advance.
-
When I open that drawing I don't see a block properties table ?
-
You won't see it until you bring up the properties manager. If you add a block properties table to the drawing, then you can see it as the "string" in the "Block properties table". I added it earlier on in the creation of this, but then decided not to use it, but I can't figure out how to remove it.
-
Give this one a try. I wblocked the drawing over itself and it fixed it. :)
-
Glad to help :)