Author Topic: Dims, it's been a while... (Read 2337 times)

craigr · « **on:** February 02, 2011, 12:00:54 PM »

I have to put some dims on a dwg and a can't remember what to set so that it show only inches.

I want 26" instead of 2' 2"

Where is this setting?

CAB · « **Reply #1 on:** February 02, 2011, 12:14:30 PM »

Do it with LISP

craigr · « **Reply #2 on:** February 02, 2011, 12:15:33 PM »

No LISP in LT.

Thanks anyway.

I just ended up doing a 'text overide' - I HATE doing it that way.

Nibster · « **Reply #3 on:** February 02, 2011, 12:18:43 PM »

I have to put some dims on a dwg and a can't remember what to set so that it show only inches.

I want 26" instead of 2' 2"

Where is this setting?

use fractional (unit format) and add a " to the suffix field under the primary units tab

JCTER · « **Reply #4 on:** February 02, 2011, 12:20:14 PM »

use fractional (unit format) and add a " to the suffix field under the primary units tab

+1

Krushert · « **Reply #5 on:** February 02, 2011, 12:23:46 PM »

Quote from: Nibster on February 02, 2011, 12:18:43 PM
use fractional (unit format) and add a " to the suffix field under the primary units tab
+1

+3.3

Daniel J. Ellis · « **Reply #6 on:** February 03, 2011, 03:31:01 AM »

surely that should be "+3 1/3"

(+ 4 1/4)

dJE

News: