Thanks for your quick reply.
Please find the attached files.
I have copied the text which has left alignment to the right side of the drawing. If you look on the right upper area, you will observed that the text marked with red rectangle is on the perfect co-ordinate as per requirement (*.00000000 or *.25000000 or *.50000000 or *.75000000). Still AutoCAD marks those text with a circle. I am preparing this lisp file for QC purpose and these things is not acceptable.
I have faced same kind of problem few months back (the program was about to insert block as per mentioned co-ordinate through lisp file, but some blocks goes here and there and not on given co-ordinate). I could not found solution for that.
Instead of checking of co-ordinate after selection, I was thinking to select those text only whose insertion point meets above mentioned condition.
Hope you will understand my problem.
Any solution for this ?
Thanks in Advance.