Quick question, I know you can use battman to reorder the attributes on/in an inserted block, but how do you fix the original. The only way I know is to insert, explode, and re wblock it out over the original version.
Your close.
Insert you block into drawing. Use Battman to reorganize to your hearts content. then Wblock the
unexploded block out and save over the original.
There is something I am forgetting so before saving over test it by saving as different name or to a different location and then reinsert the block to see if the order is revised.
I think I will go test this. It been a long time since I had to do this.****************************************************
Okay I tested it.
and it works as I described.
BuuuuutttttThere is always a butt (NO Greg, I did not call your name. IF I wanted you I would have said butt ...... Never mind)This might be a bug or something. I don't remember it doing this in ADT 05. But then again my memory is going to places I never been
I open the newly saved over block file and all the attributes were viewing as if they were left center justified. When gripped and checked with the properties pallet the justification read middle center justified as they are supposed to be. I change them to left justified and back to middle justified and they rid correctly. A quick use of the qselect command aught to help make your life easier in selecting the attributes if your results are the same as mine.
