I think I used to have this routine but, I haven't been able to find it yet.
What I need is like when you have a circuit or electrical drawing and one line crosses another without an actual connection, the line basically is broken and then an arc is drawn between the two broken parts. So, you have one solid line say running north to south and the line running from east to west has a chunk taken out of it where it crosses the N/S line and an arc spanning the chunk, in a sense, hopping over the N/S wire..
It would be nice if the chunk that's removed and the arc were somehow able to be set to a certain amount or radius or somethin, know what I mean??
OK, that's what I got.. Any ideas??