TheSwamp
Code Red => AutoLISP (Vanilla / Visual) => Topic started by: MSTG007 on September 15, 2015, 12:49:42 PM
-
Is this possible to select a polyline; select where you want to start and end; then create a solid hatch with an outline border? Trying to think of ways to highlight polyline. I could create a polyline ontop of the selected polyline and assign it a width, but I do not think that will show an outline.
I guess the second part of my question would be with the above, if you move the selected polyline will the hatch outline follow it?
Just thinking on this one...
-
The multiline command should be your friend with this trick.
-
This thread (http://www.theswamp.org/index.php?topic=43454.0) will get you most of the way there.