TheSwamp

Code Red => .NET => Topic started by: josano on November 09, 2010, 06:55:18 AM

Title: Auto dimension??
Post by: josano on November 09, 2010, 06:55:18 AM

Friends,

Researched a number automatically scale and found nothing talking about.
I've attached a picture listed.
Is to get the points for quoting?
Has anyone read or seen anything regarding this matter.
Thank you in advance any help.

Hugs,
Josano

Title: Re: Auto dimension??
Post by: kaefer on November 09, 2010, 04:23:06 PM

Quote from: josano on November 09, 2010, 06:55:18 AM

Researched a number automatically scale and found nothing talking about.

http://www.theswamp.org/index.php?topic=31861.msg386487#msg386487 (http://www.theswamp.org/index.php?topic=31861.msg386487#msg386487)? (thx to fixo)

Title: Re: Auto dimension??
Post by: josano on November 10, 2010, 08:53:05 AM

Kaefer,

Thanks for the help.
I have a question about this subject.
For dimension lines as i proceed?
I would pick the insertion points of lines.

   |------------------|---------------|
P1________________P2_____________P3___
                                                    |     |
                                                    |     |
                                                    |     |
                                                    |P4_|_

Save the clicked points and generate quota.

Hugs,
Josano

Title: Re: Auto dimension??
Post by: Kerry on November 10, 2010, 09:38:54 PM

You will also need to determine if the dimension is Horizontal or Vertical or Aligned and the line location ..

... this can't be done simply from a predetermined set of points.

Dimensioning is simple once these parameters are determined :)
unfortunately for programming, they are usually best determined by a rational mind.

HOWEVER ;
If you're dimensioning parametric shapes where the configuration can be predetermined you may be joyfull.