Topic: draworder acdorder.arx

[kim]

Hello everyone!  I am sure this has already been addressed somewhere, but I can't seem to find it.  I can't use my draworder command without getting an error message.  AutoCad says to copy a "acdorder.arx" file from another  computer, but none of them work here.  The only other option if gives me is to run set-up off the 2002 release disk, I use 2004 and jumped from 2000 to 2004 so that is not an option either,  Any suggestions?

[MikePerry]

The only other option if gives me is to run set-up off the 2002 release disk, I use 2004 and jumped from 2000 to 2004 so that is not an option either,  Any suggestions?

Hi

Install it from the 2004 installation disk.

Have a good one, Mike

[kim]

I tried to but there is no way to do that, AutoCad can't install just the one file, so it says to run set-up and do a "repair" but I don't see on the 2004 disk where or how to do that.
 

[MikePerry]

Hi

You should be able to do a "Repair Install" ->

Insert the AutoCAD 2004 installation disk, it should then automatically run, one of the options presented should be "Repair Install" (or something very similar).

If the above does not work try -

(Windows XP) Start -> Control Panel -> Add or Remove Programs -> AutoCAD 2004 -> Change button -> Reinstall or Repair AutoCAD 2004 (should be one of three options)

Have a good one, Mike