Author Topic: 2005LT mspace to pspace? (Read 2048 times)

craigr · « **on:** March 17, 2005, 12:24:12 PM »

We have MANY dwgs that are totally in mspace - no pspace what so ever.

We have recently adopted the policy that EVERYTHING is to be in pspace, to allow for viewports, if needed for some rare reason.

My question is - Is there an EASY way of changing these dwgs to pspace without copyclip'ing everything from mspace and pasting into a NEW dwg that is set up in pspace?

(These are from 2005LT to 2005LT rev.)

craigr

Kate M · « **Reply #1 on:** March 17, 2005, 12:27:49 PM »

Not in LT...but what do you mean by "everything"?

craigr · « **Reply #2 on:** March 17, 2005, 12:32:38 PM »

By 'EVERYTHING' I mean our title block, wiring diagrams, system layout, etc.... (We have our reasons)

The ONLY time that we use viewports is for our Security division, when we pasted floor plans into our title block. - (with a few RARE exceptions for our HVAC dept.)

craigr

Kate M · « **Reply #3 on:** March 17, 2005, 12:42:10 PM »

Never heard of anybody putting geometry in paperspace...but whatever works for you...

CADaver · « **Reply #4 on:** March 17, 2005, 12:43:40 PM »

CUT-N-PASTE works.

craigr · « **Reply #5 on:** March 17, 2005, 12:46:47 PM »

'CUT-N-PASTE' is the way I have been doing it.

I was HOPING that there was an AutoCad command that made it easier / quicker. - Something I could use a batch routine on.

craigr

David Hall · « **Reply #6 on:** March 17, 2005, 12:52:56 PM »

Do you have access to 1 copy of Autocad? It could be done in VBA real easily, using a script file to open , process, close.

craigr · « **Reply #7 on:** March 17, 2005, 02:15:15 PM »

No, sadly just LT.

craigr

News: