CAD Forums > CAD General

line ends with gap and dot

(1/2) > >>

confusedCADguy:
Here's a good one to keep you busy this weekend.  Has anyone ever had a line appear to have a gap with a dot at the end?  Sort of like a dimension would have. Now when I say end I mean a line drawn from point ‘a’ to point ‘b’, point ‘b’ being where the gap & dot shows up.  The strange part is no matter how close you zoom the gap never gets any bigger. And, a majority of the time it doesn’t show up until you do a regen. When you use an osnap such as endpoint it locks on to the ‘dot’ at the end of the line.  I’ve checked everything.  It’s a normal line, no ‘z’ coordinate.  I can’t really figure it out.  Any ideas?

daron:
What's the layer's and/or objects (i.e. line's) linetype?

confusedCADguy:
It didn't make a difference which layer it was on.  The linetype is continuous but I didn't check to see if it happened with other linetypes.

Keith™:
Sounds like a video card problem....

ronjonp:
Are you using any 3rd party software?

Navigation

[0] Message Index

[#] Next page