TheSwamp

CAD Forums => CAD General => Dynamic Blocks => Topic started by: Rabbit on October 01, 2012, 03:53:37 PM

Title: Look-up problem
Post by: Rabbit on October 01, 2012, 03:53:37 PM

I've got a very complex dynamic block.  When I change the look-up to a different state, it takes two selections to get the dimension along the bottom to match what the look-up is set to.  Any ideas?

Any questions, I'll be glad to answer.

Rabbit

Title: Re: Look-up problem
Post by: Krushert on October 02, 2012, 10:17:04 AM

Interesting, I see what you mean.  But I too am rustly at Look-Ups!

Title: Re: Look-up problem
Post by: Rabbit on October 02, 2012, 12:12:52 PM

For the life of me, I can't figure out why it needs two selections to make it work.  It's a time saving like it is, but it's still a PITA.