Hello,
If anyone can help me, it would be greatly appreciated.
I do a lot of fire alarm systems. My problem is the creation of one line diagrams. I have a routine I use to copy "dynamic" blocks and "annotative" scaling. Problem is it crashes on a block that is dynamic and I end up just copying blocks to the one line and then I have to do the same thing for the room names(mtext). When you have literally hundreds of these to do, it warrants asking for assistance. I have attached the oneline routine and the error trap I use. I understand that things may be done differently in both routines.
So, the ideal situation would be to...
1.) Select a block, or dynamic block "X"
2.) Copy "X" to a oneline point
3.) Next copy of "X" move the point to the right 1.5 x DIMSCALE/ANNOTATIVE SCALE
4.) Select a block, or dynamic block "X"
5.) Repeat until done
Again, I appreciate the help.
Tim