apologies if this post doesn't make a lot of sense, most of the posts have been deleted, by the authors. This response is meant for those who were involved in the exchange that took place last night.First of all, sorry you left Bob. You have been a big part of theswamp, your CAD/VBA knowledge will be missed. It saddens me when a member of theswamp leaves, for any reason.
The (
text ) you quoted Bob was from the CAD General forum, it was directed at those folks that try to help those "
does anyone have a program that will do X" posts by pasting the code directly into their response. Different forum different rules. If you look at the
sticky thread in this forum I only ask "
Please do not post copyrighted material unless you are the author or have the authors permission to do so. A link to the code works best, this gives credit where credit is due. Not to mention keeps me away from law suites.", IMO the author of this thread was not out-of-line. I know that sounds like a cop-out, it's not my intention though.
We ( the folks that work in the back ground ) try very hard to keep this place on the up-and-up both legally and morally, it's a tough job. Some of our rules tend to be more gray then black and white, that was intentional. It's hard to for see any and all problems that might arise here in theswamp so we try to leave ourselves a little leeway.
thanks for your time.