OK. I am back working on this file again. I have noticed that the data is bad but if I were to go back to the script file and do a search for the site I imported and compare it to the original data it is correct. Then I do a find in ACAD for the same site and notice that the data is incorrect. What is the deal with that. I have one site in particular that when I did a find for it I found 11 different locations on the same site all but 1 had bad data, but in the script file it was all correct. :realmad:
I have the data from the script listed below (three different locations with different cords), followed by the cords listed in ACAD for the same sites I have listed below.
-insert
"Y:\Drawings\Blks\substation.dwg"
2267858.256,16102837.71,0
-insert
"Y:\Drawings\Blks\substation.dwg"
2245349.364,16098645.25,0
-insert
"Y:\Drawings\Blks\substation.dwg"
2241600.828,16264287.05,0
2155540.3269,16172267.2910 - these are the cords where I had 11 different sites located at, but according to the script file they should not all be here. :ugly:
Any thoughts on this?