Yes I want to prepare a link for general purposes.
It is possible to combine default conditional subassemblies, generic links and daylight subassemblies to define.
But In this case too many subassemblies are requred. Even default conditional subassemly works with horizontal distance.
Sometimes vertical limititations are required.
Although my subassemblies are symetrical, why only right side goes wrong?
Most likely, your 'conditions' are not set wit a gap in the condition, e.g.
IF CUT 0-.55
followed by
IF CUT .55-1 - should be .56-1
seen this very problem in office last week by one of our engineers.
There are no 'default' conditional assemblies.
Also there is no limit to the number of conditions one can test for, and apply different assemblies to.
Perhaps you should provide a 'sketch' of what your 'conditions' are; then I can advise better.