TheSwamp

CAD Forums => CAD General => Topic started by: notredave on March 10, 2016, 10:12:19 AM

Title: Stretching a block
Post by: notredave on March 10, 2016, 10:12:19 AM

All,
Attached is a drawing of a piece of unistrut. When I insert this drawing into another drawing as a block, I can't stretch it or trim it without having to explode it. Is there a way to make a block that allows stretching and trimming without having to explode them?
Thanks in advance,
David

Title: Re: Stretching a block
Post by: mjfarrell on March 10, 2016, 10:14:48 AM

yes

dynamic blocks

add a stretch parameter


enjoy

Title: Re: Stretching a block
Post by: Rob... on March 10, 2016, 10:15:48 AM

http://www.cadtutor.net/forum/showthread.php?95999-stretching-block

Title: Re: Stretching a block
Post by: mjfarrell on March 10, 2016, 10:21:57 AM

see...


make a block

open in block editor

add a parameter  (Linear)

add an action (Stretch)