Hi all
I've got a problem with this dynamic block. It is a grille where I can set the length and width of the grille and it will automatically array the little grid bits in the middle.
It is a centre justified block (so that the locations of the grilles don't change if their size has to be changed).
Everything seems to work fine when the length (x direction) is changed, but when the width (y direction) is changed I cannot seem to get the thing to work (refer Swamp 01.pdf).
As far as I can see the bottom array marker (IWA1) should stretch with the bottom frame (IW1), the closest I've got is to get it to array but in a really weird fashion (I want the distance from centre to edge to be 30,60,60,60, etc and I wound up with 60,60,60,60, etc).
Has anyone got any idea what I've done wrong (refer Swamp 02.pdf)?
And is there a better way of doing this because this seems a bit clunky to me (I had to do the inner edges IW1, IW2, IL1 & IL2 because I didn't want the arrays to over inner (black) edges of the frame and even though those linear parameters are hidden you can still pick them as grips)?
The block is the in the attached dwg Swamp 03.dwg.
Thanks in anticipation to your help