TheSwamp

CAD Forums => CAD General => Dynamic Blocks => Topic started by: HasanCAD on February 08, 2015, 09:57:32 AM

Title: Wipeout moved to back in dynamic block
Post by: HasanCAD on February 08, 2015, 09:57:32 AM

I created a a dynamic block with a wipeout the dynamic block is OK, but when stretching the wipeout moved to back and lins apeare.

Title: Re: Wipeout moved to back in dynamic block
Post by: snownut2 on February 08, 2015, 05:27:51 PM

I would say that by stretching the lines, they where rewritten in the database putting them on top of the wipeout.

Title: Re: Wipeout moved to back in dynamic block
Post by: ChrisCarlson on February 09, 2015, 08:12:41 AM

If you regen after the stretch does the wipeout correct itself?

Title: Re: Wipeout moved to back in dynamic block
Post by: HasanCAD on February 09, 2015, 10:30:53 AM

Quote from: ChrisCarlson on February 09, 2015, 08:12:41 AM

If you regen after the stretch does the wipeout correct itself?

NO

Title: Re: Wipeout moved to back in dynamic block
Post by: ChrisCarlson on February 09, 2015, 12:08:58 PM

The issue is related to the array action, the wipeout is working, however it's set above the background but below the new array. I'm not certain there is a "fix"to this, aside from removing the wipeout and setting the center drain to be static and stretch from both ends with an array for the two slots on each end.
 

Title: Re: Wipeout moved to back in dynamic block
Post by: mjfarrell on February 09, 2015, 12:13:46 PM

suggest you try using elevation on objects to control position rather than draw order

draw the base stuff at 0

next stuff a 1

next at 2

next at 3

place wipe out at elevation to remove those things below it....2.5 or what ever makes sense

The above doesn't work..

So why not draw that center portion as fixed elements?
And allow the array/mirror of the other grate objects occur without need of any wipe out?