Hi
The below comes via an old AUGI ACAD Guild post -
-----Original Message-----
From: Mike Perry [mailto:Mike.Perry@FaberMaunsell.com]
Sent: 09 October 2002 08:59
To: Goforth, Bob; Guild-Acad (E-mail)
Subject: RE: [ACAD] Acad Question on converting a .dwf file to a .dwg file
Hi
Check out the following Technical Document's on the AutoDesk web site under the Knowledge Base section -
ID: TS64774
ID: TS11098 (Protecting a drawing from being edited - Kelvyn this one may interest you)
ID: TS65385
ID: TS59703
http://www.intelcad.com/pages/dwfin/index.htm has a Free 14 day evaluation download ObjectARX program that convert's DWF to DWG
or
A method that I just tried here, worked to some extent, not perfect but got a .DWG file -
Open .DWF file in VoloView and print to file so that a HPGL plot file is created.
Open the HPGL plot file in ViewCompanion (
http://www.softwarecompanions.com)
SaveAs .DXF file.
Open AutoCAD and used the command ._DXFIN
Have a good one, Mike