TheSwamp

CAD Forums => CAD General => Topic started by: Scott on December 06, 2006, 04:22:19 PM

Title: Lines not showing
Post by: Scott on December 06, 2006, 04:22:19 PM

Hello everyone,

I am trying to draw lines in a drawing, and they won't show up.  If I pick the starting location and the stopping location, the line shows up fine.  However, if I pick the starting location and then drag a direction and type in the line length, nothing shows up. This also happens with polylines.  Anyone have a clue what is going on?

Any help is greatly appreciated.

Scott

Title: Re: Lines not showing
Post by: David Hall on December 06, 2006, 04:25:55 PM

do you have osnaps on that might be making it snap to the beginning point?  Also, what are your units set to?  If not Arch and you type in ??'-??", decimal and others can't figure out what your typing

Title: Re: Lines not showing
Post by: Scott on December 06, 2006, 04:33:17 PM

I got is working, The number lock was turned off on my keyboard.   :oops:

Title: Re: Lines not showing
Post by: David Hall on December 06, 2006, 04:44:35 PM

That would do it for sure

Title: Re: Lines not showing
Post by: Birdy on December 06, 2006, 07:34:36 PM

spent about a half hour trying to log in one morning with that pesky problem. :)