« previous next »
Pages: [1] |   Go Down

Author Topic: Hatching sections  (Read 2135 times)

0 Members and 1 Guest are viewing this topic.

bobcats

  • Guest
Hatching sections
« on: June 22, 2010, 01:38:38 PM »
Anyone know of a hatch routine out there that will hatch a rectangle/slot into multiple hatches? Say you have a slot and you want it divided into 2,4,6,8 equal areas with hatches for each separate area and then you could delete the area you dont want as shown.
Logged

Matt__W

  • Seagull
  • Posts: 12955
  • I like my water diluted.
Re: Hatching sections
« Reply #1 on: June 22, 2010, 02:00:13 PM »
No, but worse case is you draw a rectangle, trim the hatch, then erase the rectangle.
Logged
Autodesk Expert Elite
Revit Subject Matter Expert (SME)
Owner/FAA sUAS Pilot @ http://skyviz.io

Krushert

  • Seagull
  • Posts: 13679
  • FREE BEER Tomorrow!!
Re: Hatching sections
« Reply #2 on: June 22, 2010, 03:18:38 PM »
Have you tried dynamic Blocks chock full of visibility states?
Logged
I + XI = X is true ...  ... if you change your perspective.

I no longer CAD or Model, I just hang out here picking up the empties beer cans

bobcats

  • Guest
Re: Hatching sections
« Reply #3 on: September 21, 2010, 01:37:50 PM »
bump
Logged
Pages: [1] |   Go Up
« previous next »